|
|
|
| Our machinery |
|
【One Paper-making machine】 One Tanmo and Cylinder Yankee Machine, 1100mm width
【Two Slitters】 Able to wind the paper into small rolls , 1100mm width
【One Cutter】 1000mm width
【One Band Saw Cutter】 1200mm width
Mori Paper Corporation is capable of dealing with a variety of stencil papers and can second-stage process them on your request. |
| Dissolve the pulp by water and produce a mass of individual fibers. |
Mash the fibers until they becomes a pulp.
※We are able to produce a variety of papers by changing the intensity of beating on this machine. |
| Separate the long fibers from each other. |
|
Tanmo and Cylinder Machine |
Produce wet papers--the foundation of the whole paper making process--from the fibers.
※It's possible to put two different papers up for screening with our on-line system. |
| Dries the pulp to remove excess moisture by heating the surface up with the stream in a big pressure vessel. |
Cut the papers to the desired roll length, depending on the conditions of the merchandise being produced.
※Able to produce small rolls. |
| Turning the rolls of papers flat and cutting them to the desired length. |
|
Equipped with a machine that produces a tissue paper-like softness |
Cuts soft papers and performs other paper conversions, such as converting a sheet of non-woven paper into small segments.
※We are also able to slit OEM products to your desired length. |
 |
Address: 7414, Okina, Hidaka, Takaoka,Kochi, 781-2152 JAPAN
TEL（0889）24-4122 FAX（0889）24-4038 |
|
